Coolant Overflow Bottle Bracket Installation
100113-02
Use the following procedure to install the coolant overflow bracket.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
ICA011506 (BRACKET, COOLANT OVERFLOW BOTTLE, ASSY)
CB9120V5 (MOUNT, CABLE TIE ANCHOR)
TY24MX (CABLE TIE)
Aircraft System and Number
13—Propulsion
Safety Equipment
As Needed
Consumables
EA9394 (ADHESIVE, HYSOL)
LOCTITE®243™
Task Instructions
1. If installing a new coolant overflow bottle bracket, prepare it as follows:
b. Lightly abrade the bonding area of the bracket and clean with isopropyl alcohol.
c. Bond the anchor to the bracket with Hysol Adhesive EA9394 as shown. Allow to cure for 2 hours.
Figure 443. Coolant Overflow Bottle
2. Install the coolant overflow bottle bracket on the engine as shown in Figure 444. using the noted hardware. Apply LOCTITE® 243™ to the screw threads.
Figure 444. Coolant Overflow Bottle
3. Torque the two M8 bolts to 17.7 ft-lbf (212 in-lbf). Torque the M10 bolt to 25.8 ft-lbf (310 in-lbf).
4. To re-install the existing coolant overflow bottle, use two TY29MX cable ties as shown in Figure 445. Orient the bottle with silicone hose facing forward (away from propeller flange).
Figure 445. Coolant Overflow Bottle
5. If the coolant overflow bottle needs to be replaced, See Replace
Overflow Bottle Overflow Hose and Cap.
6. Fill the overflow bottle to the mid-range level with new coolant. (Approved Engine Coolant Grades and Capacity)
Verification Method
Procedure is complete when steps are finished.
Parent topic