1

Check that battery is free of corrosion and secure

2

Perform battery capacity test in accordance with latest release of Concorde Maintenance Manual

3

Perform ELT inspection/functional check. Record ELT battery expiration date. ELT Inspection and Function Check

4

Inspect antenna mount and wiring for security

5

Inspect ELT antenna for corrosion. (ELT Antenna Corrosion Inspection)

6

Check wires to battery ground

7

Inspect radio/leads/wires for attachment and security

8

Inspect wiring instrument panel for attachment and security

9

Check bilge pump for function, clear of debris.

Check Bilge Pump Function Bilge Pump Debris Removal

10

Check wiring harness for chafing/security/condition.Inspect, Repair, and Secure Wiring Harness with Signs of Chafing

11

Check for wire/connector strains

12

Calibrate AOA pressure transducer. Calibrate AOA Pressure Transducer

13

Verify regulator B fan is operating with master power turned on

14

Inspect regulator B wires for browning near connector.

15

Inspect regulator A wire for browning near connector. Inspect Regulator Wires

16

Inspect Rotax fuse box for blown fuses and correct sized fuses are installed

17

Inspect overhead panel for blown fuses and correct sized fuses are installed.Replace Overhead Console Fuses

18

Inspect connections at Garmin and/or Autopilot Controller unit for attachment and security. (G3X and/or Autopilot Configuration Only)

19

Verify proper operation of the Autopilot Servos on the ground in accordance with section 30.4.10.6 Autopilot Setup of G3X/G3X Touch Avionics_Installation Manual (Autopilot Configuration Only)

20

Inspect Pitch Servo for secure attachment, integrity of connetors and wiring, cleanliness, and any evidence of damage. To access, see Baggage Floor Removal. (Autopilot Configuration Only)

21

Inspect Roll Servo for secure attachment, integrity of connectors and wiring, cleanliness, and any evidence of damage. To access, see Headliner Removal. (Autopilot Configuration Only)